JSE Racing | Other
JSE Racing
Phone: 1300 136 318
Reviews
to load big map
23.01.2022 C10’s 357sbc initial start up after the rebuild.
23.01.2022 L98 corvette aluminium with stainless headers And exhaust
23.01.2022 Custom lasercut trans cooler bracket.
22.01.2022 Progress on the 427 engine build. Crank installed and torqued to specs.
22.01.2022 Eastern Creek Raceway
22.01.2022 Distributor and ignition leads install
21.01.2022 Main bearings, rear main seal installed and lubed with pre assembly oil... crank installed with correct clearances and main billet splayed caps using an arp main stud kit all torqued down to the spec torque settings
20.01.2022 Checking main bearing clearances
20.01.2022 Checking installed spring height and ft. lbs. @ valve closed
19.01.2022 Changing the valve springs for the crane cams hydraulic roller lifters
19.01.2022 The 1980 c10 shortbed truck
19.01.2022 Mazda turbo rebuild
18.01.2022 Trial fitting my new 1.6 Jessel shaft mounted roller rockers
17.01.2022 Lasercut 2 bolt steel main cap girdle with arp studs
15.01.2022 C10s 357sbc initial start up after the rebuild.
15.01.2022 Progress on the 427 engine build. Crank installed and torqued to spec.
15.01.2022 Modifying 427ci rocker covers
14.01.2022 Grout filling the block with a torque plate
12.01.2022 Ceramic coated weisco pistons, h/d thick wall pins on H beam 3D rods with arp L19 rod bolts are ready for assembly
11.01.2022 Finished and running with exhaust and accessories... now for the blower !!
08.01.2022 Custom lasercut coil mount
08.01.2022 Getting closer. Dusted the cobwebs and took it for a spin after a long period of updates.
07.01.2022 Rebuilt 12bolt with posi and 3.42 ratio gears
07.01.2022 The camaro washed up nicely.
02.01.2022 Top Seal Ring gaps filed for the 427sbc
02.01.2022 0.030 thou off-set head dowels installed
01.01.2022 Setting up the crank shaft run out clearance with a dial gauge and wet n dry 600 grit paper to cut back the thrust bearing surfaces
01.01.2022 Ran a respectable 11.6@119mph... with more tuning and water-meth injection looking to break into the 10s.
