Australia Free Web Directory

Odlaw Industries in Perth, Western Australia | Automotive repair centre



Click/Tap
to load big map

Odlaw Industries

Locality: Perth, Western Australia

Phone: +61 8 9409 9686



Address: 1/11 Prindiville dr Wangara 6065 Perth, WA, Australia

Website:

Likes: 3313

Reviews

Add review

Click/Tap
to load big map

18.01.2022 Finally got some deadly 5 inch side pipes done on the workshop ute. Jeffy the Effy. All rough to suit the look. Also a Killa logo on the doors.... Huge thanks to all the peeps that came up with a few designs and tweaks here and there. Legends



17.01.2022 Just a simple conversion. V6 Commodore motor, manual gearbox wedged into a Datto 1600. Yep, Cool. We did a neat mild steel single system to keep the sound down a bit.

15.01.2022 Tuff and Clean XB Coupe came in for a bit of a different set up. Twin 3 inch into twin 2 1/2 tails. The different bit is a pair of FG Falcon Bi-Modal mufflers grafted in.... Sadly had some bad spark plugs so couldn't run it properly.

13.01.2022 2 door Falcon came in for a some flash bits before it goes off to get panel and paint. Nice RHD conversion too. Married up to Hedman hedders is a twin 2 1/2 stainless steel, tig welded system with Magnaflow mufflers and twin side exit on drivers side.... Yes we know the tips are not central. Stainless grows a lot when it get's hot so once it has been driven a bit and settles in we will tweak it. Those efi throttle bodies though



13.01.2022 Fine example of a COBRA replica came in. Had some weird press bent choked up system on it. We did a neat twin 2 1/4 mild steel, mandrel bent system with high flow cats and then tucked the tail pipes up under the rear end per customers request.

08.01.2022 Nothing to see here, move along Just an Alternator upgrade that needed some fresh "cooler" piping. The old stuff looked good painted black but was mild steel, not the best for intake pipe.

07.01.2022 XA Falcon Coupe with twin stainless steel 3 inch into 2 1/2 mufflers. (It will be back for tail pipes but no time to do it at the moment) Late night Friday and all day Saturday but got it done. Customer is powering through to get this done for a wedding so I came in and sorted it out after hours.... (The suspension is next, level the car out) Been a while since I did some tig welding so it was good to get on it. Magnaflow Magnaflow Australia



01.01.2022 Something for the Haters 280 Datsun with a Holden 5ltr injected V8 in it. Custom stainless intake pipe.... Stainless twin 2 1/2 into magnaflow muffler then twin 2 1/4 into small resonators and 4 inch tips. Very cool and sounds mint

Related searches