Youman's Race Fabrication in Torbanlea, Queensland, Australia | Automotive, aircraft & boat

Youman's Race Fabrication

Locality: Torbanlea, Queensland, Australia

Phone: +61 435 795 122

Address: 33 roberts road 4662 Torbanlea, QLD, Australia

Website:

Likes: 266

Add/Update information

Reviews

Tags

• Automotive, aircraft & boat
• Automotive
• aircraft & boat

25.01.2022 A bit of a quad bike fit out from last week! Rear aluminium toolbox and ally gun rack at the front. Been away for a hunting trip now it’s time to come back for a shooters rack and a few more mods

20.01.2022 Been busy making a new rear end and adding a cross brace in the shock tower to stop ot from cracking.

18.01.2022 Put the engine in the #boostedtt today and mocked up the exhaust

17.01.2022 Better late then never. Over 6 months ago now I pretty much completely rebuilt the holiday, stripped it back, rebuilt the whole rear end, modified the steering to eliminate the bump steer, repainted the car and strengthened up the front suspension towers. Here’s a few build photos from throughout the build

15.01.2022 Aluminium dash i build in the 527 hilux. Building a dash for a trophy truck next week!

11.01.2022 Been very slack with posting on this page lately but I’ve been very busy rebuilding the front end on my hilux ready for next years season. Here’s a few photos of the build process so far cutting the barwork off back to the chassis and remounting the top arms to make the suspension work better. Invite your friends and share the page around to follow my build and other builds along the way

10.01.2022 Making progress on the new diff housing for the #hiluxV2. Little bit more sheet work to do before making a jig and zapping it up

09.01.2022 A few progress photos of the #hiluxV2 build

09.01.2022 A few more photos of the diff housing for #hiluxV2. Just about finished the jig and then it’s to to start the welding process!

02.01.2022 Here’s another update on the #hiluxV2 front end rebuild, all the tubework is just about finished, time to pull the engine out so I can gusset some corners, mount the bump stops and make a couple of sheetmetal crossmembers. Then it’s time to weld it up and make the stainless 4 inch twin intake and some ally panels before painting.

01.01.2022 Almost time to weld it all up, top cross member is almost complete and the bumpstops are mounted. Just need to put some holes in the crossmber to put some tubes through then it’s time to weld it up and add in a few gussets along the way

01.01.2022 The hilux is almost back together after stripping the rear end down and painting it. Almost time to go racing again next job, remount and strengthen the busted 4 link mounts on a comp truck